Override module parameters with "Send to Module" action

[rebmanna]

Hi,

at the moment, it is still very difficult to pass the current parameters and the data for the input action to a module.

At the moment, i do this:

1. Set a stop in the called module -> override/save Module with new parameters

2. Send/Save output to Module (save Module) -> disable breakpoint

If the process were as shown here, depugging would be much easier

... or is there a way to do this in one step at the moment, wich i don't see ?

it's similar this request ...
Pass a parameter to other module - General Q&A - EasyMorph Community - Data preparation professionals and enthusiasts

regards,

Adrian

[AndreaM]

Hello @rebmanna ,

unfourtunately this is the only way but there is a new feature on the way:

Set module parameter from current status

Hello everyone, while using module I found an opportunity for a good feature: when you call a module, you set the parameters and then, in the module, you’ve to configure the parameters again with some value. It would be great if it’ll be possibile to set these parameters from the main module, on the iteration action. This feature already works when the module raise an error (it appears a window where you can push current value in the module and open it to debug). Why we need this? Because, s…

Crossing fingers!

[rebmanna]

Hi AndreaM,

yes, this is also the way, i do it at the moment.
Therefore thes featurerequest

regards,

Adrian

[rebmanna]

thanks again, found it but...
this feature would also be nice here ...

regards,

Adrian

[AndreaM]

I agree with you!